Duro-last Duro-Flash II User Manual download pdf

Duro-Last: The Proven Performer®

"Duro-Last" and "The World's Best Roof" are registered marks owned by Duro-Last , Inc.

www.duro-last.com

800-248-0280

DATA SHEET

2009

DURO-LAST® DURO-FLASH II

Description:

Duro-Last® Duro-Flash II may be used as a

termination under existing metal counterflashing.

It is fabricated from 3 inch wide vinyl coated metal

and a 12 inch (152 mm) wide skirt. The skirt is made

of Duro-Last specially formulated roofing membrane,

which is a proprietary thermoplastic formulation,

available in white, tan, gray and dark gray colors.

Duro-Flash II is available in 10 ft. (3 m) lengths. The

skirt extends past the vinyl coated metal 3 inches (76

mm) on each end to allow adjacent sections to be

heat welded (hot-air) together.

Installation:

1. Duro-Flash II shall be slid under the existing metal

counterflashing 1 inch (25 mm), minimum (this is

the width of the factory weld).

2. The skirt shall be held up to allow Duro-Last

fasteners to be placed 6 inches (152 mm) on

center, maximum, through the metal into the wall

substrate.

3. Heat weld (hot-air) the skirt to the Duro-Last

membrane already installed below the metal.

4. Refer to detail drawing #6142.

Notes:

• Duro-Flash II is ordered in 10 ft. (3 m) lengths and

packaged in cardboard boxes.

Page 1

Duro-Last: The Proven Performer®"Duro-Last" and "The World's Best Roof" are registered marks owned by Duro-Last , Inc.www.dur

No comments

Duro-last Duro-Flash II User Manual